The UTCM-0578 Gillmore Apparatus is used to determine the setting time of cement hydraulic hydrometer lime and mortar. Apparatus consists of two horizontally positioned arms, carrying weighted needles, initial needle...
UTCM- 0720A and 0730A Flow ConeTest Sets are used for determining the flow properties of grouts, mortars, muds and other fluid materials. The test set with a 0.75" (19 mm)...
The UTCM-0240 Blaine Air Permeability Apparatus is used to determine the fineness of Portland cement, limes and similar powders expressed in terms of their specific surface. Standards EN 196-6; ASTM...
The Vicat Test Set is used for the determination of the setting time and consistency of cement by Vicat Method. UTCM-0458 Transfer Dish which is used as a Water Wessel...
The setting time determination of cement/mortar/gypsum is one of the most important parameter for the quality inspection and verification. The machine is based on the innovative CVI-TECH philosophy. On the...
The UTCM-0020 High Pressure Cement Autoclave is designed to perform expansion tests on cement specimens. 10 specimens can simultaneously be tested in the high pressure steam vessel of 154 mm...
Length Comparators are used to determine the length changes on different type of hardened mortar and concrete prisms with different sized. The sets consist of a length measuring frame with...
All moulds have been manufactured from steel except UTCM-0898 molded using engineered plastic and all internal surfaces are machined. Standards EN 196-1; ASTM C109, C348;BS 4550 Minimum surface hardness of...
The moulds are used for preparing the specimens for the purpose of determining the length changes (shrinkage/expansion) in hardened concrete and hydraulic cement mortar. Standards ASTM-C157, C1105, ASTM C151, C452, C490,...
A wide range of flexural testing machines to support specific requirements of clients can be custom produced. Some examples of special flexural machines and frames produced by Utest are shown...
The UTEST Semi-Automatic range of 200 kN capacity flexure testing machine was been designed for reliable and consistent testing of flexural test on standard concrete beams, concrete or natural stone...
The UTC-5533 100 kN Capacity Manual Flexure Testing Machine is designed to perform reliable flexure tests on standard concrete beams, concrete or natural stone kerbs, concrete paving flags, and natural...
The UTCM-3722.MLP and UTCM-3742.MLP single and double testing chamber Manual compression and flexure testing machines are designed to perform reliable strength and flexure tests on mortar specimens. The manual machines...
There are two models of the Cement Flow Table according to ASTM and EN standard. Both are used for determining the consistency of mortar, lime and cement specimens. Also manual...
UTC-5501 Flexural Testing Assembly for Concrete Beams The test assembly, conforming with EN 12390-5, ASTM C78, ASTM C293, BS 1881:118, is used for center or two-point (third-point loading-ASTM) loading flexural...
UTEST 600 kN capacity Flexural Frame is designed for minimum deflection at maximum load resulting in very high accuracy. The load frame is a four column design carrying the ram...
