The UTB-1400 Ductility Testing Machine is used to determine the ductility of bituminous materials in a briquette mould by measuring the breaking elongation at a constant speed of 50 mm/min....
The UTB-1430 Force Ductility Testing Machine is used to determine the the deformation energy required to stretch a bitumen sample from 200 mm elongation to 400 mm elongation. Force ductility...
Melting Pot 3 L Capacity Models for 110-120V 60 Hz, 1ph. CEN ISO/TS 17892-2; EN 12390–3, 12390-1, 12504-1; ASTM C31, C192, C617; AASTHO T23, T126 The Melting Pot is designed for...
Assemblies are used for determining the softening point of bituminous materials by ring and ball method with UTD-1412 or UTD-1410Y hot plate. Standards EN 1427; ASTM D36; AASHTO T53 Hot...
UTEST UTB-0240 Automatic Ring and Ball/Softening Point Tester is an innovative microprocessor controlled automatic testing device which is used for determining the softening point of bituminous materials using water or...
The UTB-1360 TAG Open Cup Flash Point Tester is used for determination of flash points of. The test set consists of an electric furnace with electronic controller of heating power,...
The UTB-1350 Cleveland Flash Tester is used for determining the flash and fire point of petroleum products. It consists of a brass cup mounted on an electric heater with a...
The UTB-0120 Semi-Automatic Digital Bitumen Penetrometer is used to determine the penetration of bituminous samples under constant load, time and temperature. The Penetrometer consists of a frame with a leveling...
The UTB-0126 Automatic Electronic Penetrometer is used for determination of the needle penetration according to EN 1426, ASTM D5 and AASHTO T49 standards. The penetration depth of the needle is...
UTB-0130 Fully Automatic Electronic Bitumen Penetrometer with automatic surface detection is used for determination of the needle penetration according to EN 1426, ASTM D5 and AASHTO T49 standards. The penetration...
VDO Touch by ATS is an automated tabletop degassing oven with an internal vacuum system, designed for rapid removal of entrapped air bubbles in asphalt specimens to the required 15 ±1.0kPa...
Pyrolytic Oven is a second-generation, high-temperature oven that replaces the obsolete Pyro-Clean™ model. The Pyrolytic Oven is used for performing safe, solvent-free cleaning of asphalt and other organic residues from laboratory...
Bending Beam Rheometers (BBR) by ATS measure the flexural creep stiffness of asphalt binder from ambient to -40°C to predict low-temperature thermal cracking of asphalt pavements. Special molds form small...
Dynamic Shear Rheometers (DSR) classify asphalt binders based on their resistance to damage from age, temperature, and mechanical forces over a wide temperature range. DSR’s are particularly important in characterizations...
Rolling Thin-Film Ovens are used for determination of the resistance to hardening of semisolid asphaltic materials/ bitumen or bituminous binders under the combined effects of heat and air with the...
The Saybolt Viscometer is used to determine empirical measurement of Saybolt Viscosity of petroleum products at specified temperatures. The time it takes for a 60mL sample to flow through a...
The UTB-1250 Digital Engler Viscometer is used for determining the viscosity of tars and their fluid products. Apparatus consists of a contact thermo regulator and a stirring device. Standards ASTM...